Your water heater is one rather used and costly appliances in your home, and consumes a large regarding your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving with regards to your home heating as well as costs.
Regular flushing of the water heater is among the single most important step you can take to prolong its service life and even save energy. For time, sediments enhance in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not only destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most regions of the country, the typical water heater lasts 3-5 years. Regularly flushing your water heater can double living of your water heater from 3-5 to 7-10 years. Are investigating costs of replacement running from $700 to over $1200 in some cases, getting the most out of your heater is vital in today’s markets. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs in half. Depending on the volume of warm water your home uses, that can mean a savings of $20 to over $50 a week.
To drain your water heater, you can find should set the thermostat to pilot (if it is really a gas water heater) or turn the circuit breaker off (if it is an electric heater). Failure to do so could result in overheating and severe damage to drinking water heater. Next, close the water supply valve located more than a water inlet line going into your water heater. You may then connect a garden hose to the drain valve located at the base of the heater. Open the drain and allow it to move until all of your water has emptied from the unit. Then close the drain. Open the water supply valve and refill the heater. You should also open a hot water faucet somewhere indoors and stand there and watch it run for several minutes until the water flows out quietly. This will allow air to vent via the heater and the water lines. Finally, you can turn the thermostat in order to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your dwelling to filter or condition the water so it is less corrosive to your plumbing system, particularly in areas which have hard water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in your area to discuss options and merchandise to suit your needs.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX